Description Of Inconel 600
Inconel600 is an early developed nickel-chromium-iron-based solid solution strengthening alloy, which has good high temperature corrosion and oxidation resistance, excellent hot and cold processing and welding process performance, and has satisfactory thermal strength and high Plasticity.
The alloy can be strengthened by cold working, and can also be connected by resistance welding, solution welding or brazing. It can supply cold-rolled thin plate, hot-rolled thick plate, strip, wire, bar, round cake, ring blank, ring forging, etc. It is suitable for making anti-oxidation parts with low load below 1100 ℃. Alloy 600 is a non-magnetic nickel-based superalloy that combines high strength, hot and cold workability and corrosion resistance. And the alloy exhibits very good heat resistance. During the entire annealing to severe cold working process, there will be no aging corrosion or stress corrosion.
Inconel 600 chemical composition
Carbon 0.10% or less
Sulfur 0.015% or less
Manganese below 1.00%
Silicon 0.50% or less
Nickel 72.00% or more
Inconel 600 Physical Properties
Specific gravity: 8.43
Density: 0.3070 lb / in3
Average specific heat (77-212 ° F): 0.1090 Btu / lb / ° F
Average thermal expansion coefficient
Thermal conductivity: 104.0BTU-in / hr / ft2 / ° F
Modulus of elasticity (E)
Tension and compression: 31.0 X 103 ksi
Torsion and compression: 11.0 X 103 ksi
Resistance (77 ° F): 620.0 ohm-cir-mil / ft
Melting distance: 2540 ° F
Effect of cold rolling on hardness
Inconel 600 Stress cracking strength
Tensile strength of warming environment
Alloy 600 can not be hardened with age, but can be hardened by cold work.
The temperature at which the softening annealing starts is 871 ° C, and the annealing can be finished by heating at 982 ° C for 10-15 minutes. Exceeding 982 ° C will produce undesirable grain growth, but a little heating at 1038 ° C can completely soften the material without excessive grain growth.
The cooling rate does not affect the softening effect, so it can be quenched with water or air cooled.
Low sulfur reduction furnace atmosphere can be used to forge 600 alloy. Most of the work of thermal machining should be carried out in the temperature range of 1260-1010 ° C, a small amount of thermal machining can continue until the temperature drops to 871 ° C. The ductility of the material is low between 871 and 649 ° C, so it is not suitable for hot processing.
Inconel 600 Machine Plus
Both the hot-worked state and the annealed state of alloy 600 can be machined. Because this material generates a lot of heat when machined, high-speed steel, non-ferrous metal castings or cemented carbide tools should be used, and the tools should be kept sharp.
The turning speed of high-speed steel and non-ferrous metal tools is 0.18-0.23m / s, and the turning speed of cemented carbide tools is 0.51-0.89m / s. The speed range is an average value, and the speed and feed amount need to be adjusted according to the actual situation of the workpiece.
Lubricants need to be sulfur based. Before heating, such as welding, the lubricant must be completely removed.
Link to this article： What is Inconel 600?
Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting:https://www.cncmachiningptj.com/，thanks！