Home » Stamping Machine News » Introduction of common specifications and models of punches

Introduction of common specifications and models of punches

Posted by: ANDY Minghe 2021-10-08 Comments Off on Introduction of common specifications and models of punches

Introduction to common specifications and models of punches

Punch is essentially a stamping press. Compared with more traditional processing machinery, this equipment saves materials and energy, is more efficient, and does not require high technical requirements for operators. Therefore, it is used in many industries. Wide range of applications. Today, the editor introduces the common specifications and models of the equipment. Those in need can find out.
usual format:

Calculated according to the standards of our country’s punch presses are: 10T, 15T, 25T, 40T, 60T, 80T, 100T, 120T, 160T, 250T, of course this is also called according to the Taiwan standard. Its technical parameters can refer to the following table:

Model: There are mainly two types: J23-10 and J23-40
Model: J23-10:
Nominal force 100kN;
Slide stroke 45mm;
The number of trips is 145 times/min;
Maximum closed height 180mm;
The closed height adjustment is 35mm;
The distance from the center of the slider to the body is 130mm;
The size of the worktable is 240mm front and rear, 370mm left and right;
The size of the worktable hole is 130mm front and rear, 200mm left and right, 170mm in diameter;
The floor size of the slider is 150mm front and rear, 170mm left and right;
Die handle hole size is 30mm in diameter and 55mm in depth;
The distance between the columns is 180mm;
The thickness of the worktable is 35mm;
The maximum tilt angle of the fuselage is 30°;
The external dimensions of the press are 900mm front and rear, 697mm left and right, and 1658mm high;
Motor power 1.1kw, speed 930 rpm;
The total weight of the press is 576kg.

Model: J23-40
Nominal force 400kN;
Slide stroke 80mm;
The number of trips is 45 times/min;
Maximum closed height 330mm;
The closed height adjustment is 65mm;
The distance from the center of the slider to the body is 250mm
The size of the worktable is 460mm front and rear, 700mm left and right;
The size of the worktable hole is 250mm front and rear, 360mm left and right, and 320mm in diameter;
The floor size of the slider is 260mm front and rear, and 300mm left and right;
Die handle hole size is 50mm in diameter and 70mm in depth;
The distance between the columns is 340mm;
The thickness of the worktable is 65mm;
The maximum tilt angle of the fuselage is 30°;
The external dimensions of the press are 1685mm front and rear, 1325mm left and right, and 2470mm high;
Motor power 4kw, speed 1440 rpm;
The total weight of the press is 3540kg.

Link to this article:Introduction of common specifications and models of punches

Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting:Stamping Wiki,Thanks!^^