The use process of stamping anchor pallet punching machine is to use the press to cooperate with the mold to perform pressing, punching and other processes. According to the characteristics and requirements of different punch products, the corresponding molds are designed.
Different mold structures have different functions and different products. Generally speaking, there are simple and complex. But no matter how complicated the structure is, its basic structure remains the same.
Steps to install the die on the punching press of the anchor pallet:
- 1. Before installation, make sure that the cutting edge of the mold is sharp, there is no chipping on the cutting edge of the die, and there is no missing corner on the punch. If there is chipping or chipping, please sharpen the knife first.
- 2 Before closing the mold, a silicon steel sheet should be inserted between the upper and lower molds to prevent damage to the knife edge due to the handling process.
- 3. Before the punching die of the punching anchor tray is installed on the punching machine, use oilstone to grind off the burrs on the bottom surface and the upper surface, and clean up the garbage with cloth strips. If there are burrs or rubbish on the upper and lower planes of the mold, it will cause the punching burrs to be out of tolerance.
- 4. Adjust the stroke of the slide block to a proper position and press the upper mold. Make sure that the upper surface of the mold handle or mold base is tightly attached to the bottom surface of the slide block, and the lower mold pressure plate screws are gently pressed. Then, adjust the slider upwards and take out the silicon steel sheet in the middle. Loosen the screws of the lower mold pressing plate and adjust the slider downwards until the male mold enters the female mold 3~4mm, and then tighten the screws of the lower mold pressing plate. When the new die is punched, the punch must enter the female die by 3~4mm, otherwise, the punch or the die will burst.
Link to this article：How to install the die on the punch anchor pallet punch.
Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting:Stamping Wiki，Thanks！^^